Master Cisco CCNA Exam 200-301: Your Gateway to Network Stardom
How is a configuration change made to a wireless AP in lightweight mode?
Correct : C
Start a Discussions
How do traditional campus device management and Cisco DNA Center device management differ in regards to deployment?
Correct : D
Start a Discussions
Refer to the exhibit.
Which set of commands must be applied to the two switches to configure an LACP Layer 2 EtherChannel?
A)
B)
C)
D)
Correct : A
Start a Discussions
What are two reasons to implement DHCP in a network? (Choose two.)
Correct : D, E
Topic 5, Simulations / Lab
Start a Discussions
SIMULATION
All physical cabling between the two switches is installed. Configure the network connectivity between the switches using the designated VLANs and interfaces.
1. Configure VLAN 100 named Compute and VLAN 200 named Telephony where required for each task.
2. Configure Ethernet0/1 on SW2 to use the existing VLAN named Available.
3. Configure the connection between the switches using access ports.
4. Configure Ethernet0/1 on SW1 using data and voice VLANs.
5. Configure Ethemet0/1 on SW2 so that the Cisco proprietary neighbor discovery protocol is turned off for the designated interface only.
Correct : A
Answer as below configuration:
on sw1
enable
conf t
vlan 100
name Compute
vlan 200
name Telephony
int e0/1
switchport voice vlan 200
switchport access vlan 100
int e0/0
switchport mode access
do wr
on sw2
Vlan 99
Name Available
Int e0/1
Switchport access vlan 99
do wr
Start a Discussions
Total 970 questions