Boost Your Skills with Free Practice Questions for JN0-363 Certification

Question 1

You want to see a detailed list of all established BGP sessions. In this scenario, what would be a valid command to accomplish this task?

Ashow bgp neighbor

Bshow bgp summary

Cshow rouse receive-protocol bgp <neighbor IP address>

Dshow rouse protocol bgp

Correct : A

Options Selected by Other Users:

Mark Question:

Start a Discussions

Submit Your Answer:

Ashow bgp neighbor

Bshow bgp summary

Cshow rouse receive-protocol bgp <neighbor IP address>

Dshow rouse protocol bgp

Question 3

Exhibit

You are asked to configure OSPF between routers R1 and R2 using IPv6 addresses.

Which two tasks will accomplish your objective? (Choose two.)

AIssue the sec protocols ospf area 0.0.0.0 interface ge-0/0/1.0 command.

BUnder the [edit routing-options] hierarchy, configure a 32-bit router ID.

Cissue the set protocols ospf3 area 0.0.0.0 interface ge-0/0/1.0 command.

DUnder the [edit routing-options] hierarchy, configure a 128-bit router ID.

Correct : B, C

Options Selected by Other Users:

Mark Question:

Start a Discussions

Submit Your Answer:

AIssue the sec protocols ospf area 0.0.0.0 interface ge-0/0/1.0 command.

BUnder the [edit routing-options] hierarchy, configure a 32-bit router ID.

Cissue the set protocols ospf3 area 0.0.0.0 interface ge-0/0/1.0 command.

DUnder the [edit routing-options] hierarchy, configure a 128-bit router ID.

Question 4

You want to enable a routing platform with redundant REs to switch from a primary RE to a backup RE without alerting peer nodes. Which two technologies would you use to satisfy this requirement? (Choose two.)

AGRES

BVRRP

CNSR

DISSU

Correct : B, C

Options Selected by Other Users:

Mark Question:

Start a Discussions

Submit Your Answer:

AGRES

BVRRP

CNSR

DISSU

Question 5

You are troubleshooting two OSPF routers that have an adjacency that remains in the ExStart state.

What would cause this problem?

Amismatched OSPF hello intervals on the OSPF interfaces

Bmismatched authentication settings on the OSPF interfaces

Cmismatched MTU settings on the OSPF interfaces

Dmismatched subnet settings on the OSPF interfaces

Correct : C

https://www.cisco.com/c/en/us/support/docs/ip/open-shortest-path-first-ospf/13684-12.html#anc13

Neighbors Stuck in Exstart/Exchange State The problem occurs most frequently when you attempt to run OSPF between a Cisco router and another vendor router. The problem occurs when the maximum transmission unit (MTU) settings for neighboring router interfaces do not match. If the router with the higher MTU sends a packet larger that the MTU set on the neighboring router, the neighbor router ignores the packet. When this problem occurs, the output of the show ip ospf neighbor command displays output similar to what is shown in this figure.

Options Selected by Other Users:

Mark Question:

Start a Discussions

Submit Your Answer:

Amismatched OSPF hello intervals on the OSPF interfaces

Bmismatched authentication settings on the OSPF interfaces

Cmismatched MTU settings on the OSPF interfaces

Dmismatched subnet settings on the OSPF interfaces

Master Juniper Service Provider Routing and Switching Specialist JN0-363: Your Gateway to Network Excellence

Options Selected by Other Users:

Options Selected by Other Users:

Options Selected by Other Users:

Options Selected by Other Users:

Options Selected by Other Users: