HPE7-A08 Exam Demo Questions - Preview Actual Exam Format

Question 1

Your customer has an existing gateway cluster that they are using to tunnel traffic from APs and would like to configure the same for their CX switches. Which tunneling option should you recommend?

AUBT

BIPSec

CGRE

DVNBT

Correct : A

Options Selected by Other Users:

Mark Question:

Start a Discussions

Submit Your Answer:

AUBT

BIPSec

CGRE

DVNBT

Question 2

You are verifying a new VSX deployment and have run the following command. Based on the output, which statement is true?

AThis device has the highest configured VSX priority.

BISL failure would result in a split-brain condition.

CVSX on both switches is in a healthy state.

DThe ISL has been configured in the mgmt VRF.

Correct : B

Options Selected by Other Users:

Mark Question:

Start a Discussions

Submit Your Answer:

AThis device has the highest configured VSX priority.

BISL failure would result in a split-brain condition.

CVSX on both switches is in a healthy state.

DThe ISL has been configured in the mgmt VRF.

Question 3

You are configuring OSPF on each of the devices shown. After verifying the OSPF neighbor table on each, you notice that Router-1 and Access-1 have neighbors in the 2WAY state. What is the reason for this?

ARouter-1 and Access-1 have reached a tie in the DR election.

BRouter-1 and Access-1 have no OSPF networks to advertise.

CThis is normal behavior for OSPF neighbors on a broadcast network.

DIGMP snooping has been configured on Router-1 and Access-1.

Correct : C

Options Selected by Other Users:

Mark Question:

Start a Discussions

Submit Your Answer:

ARouter-1 and Access-1 have reached a tie in the DR election.

BRouter-1 and Access-1 have no OSPF networks to advertise.

CThis is normal behavior for OSPF neighbors on a broadcast network.

DIGMP snooping has been configured on Router-1 and Access-1.

Question 4

You need to find which change was made to the HPE Aruba Networking CX switch from the GUI. Which option can you use?

AUse checkpoint diff to compare running-config with stored saved-config revisions

BUse show checkpoint diff to compare running-config with stored checkpoints

CUse show checkpoint diff to compare running-config with stored saved-config revisions

DUse checkpoint diff to compare running-config with stored checkpoints

Correct : C

Options Selected by Other Users:

Mark Question:

Start a Discussions

Submit Your Answer:

AUse checkpoint diff to compare running-config with stored saved-config revisions

BUse show checkpoint diff to compare running-config with stored checkpoints

CUse show checkpoint diff to compare running-config with stored saved-config revisions

DUse checkpoint diff to compare running-config with stored checkpoints

Question 5

OSPF peering is configured between HPE Aruba Networking CX 6300 switches utilizing BFD. You've made this configuration on switch B, while switch A is in the default configuration:

Which BFD Tx/Rx interval values will switch A use for the show bfd session?

ASwitch A show BFD sessions using 500ms

BSwitch A show BFD sessions using 6000ms

CSwitch A show BFD sessions using 2000ms

DSwitch A show BFD sessions using 300ms

Correct : C

Options Selected by Other Users:

Mark Question:

Start a Discussions

Submit Your Answer:

ASwitch A show BFD sessions using 500ms

BSwitch A show BFD sessions using 6000ms

CSwitch A show BFD sessions using 2000ms

DSwitch A show BFD sessions using 300ms

Master HPE Network Switching Professional Exam HPE7-A08 with Confidence

Options Selected by Other Users:

Options Selected by Other Users:

Options Selected by Other Users:

Options Selected by Other Users:

Options Selected by Other Users: